Most of the time, companies would spend lots of money to buy their forklifts. It is essential, therefore to take proper care of your equipment to protect your investment into the long run. It is a great idea to know the procedures which are undertaken in taking care of and maintaining this equipment.
By starting up the forklift and listening closely how it runs is among the best ways to tell how good the engine is running. Like for example, if there are any knocks or misses, the machinery is defective and this must raise several concerns. Furthermore listen carefully for any squealing sounds that come from the belts because these sounds will provide you with a lot of information.
When carrying out maintenance, some of the main parts you would have to pay attention to include the horn, safety warning devices, the lights, the gauges and the overhead guard. Any faulty parts or burnt out light bulbs should be replaced as soon as they are noticed. It is also essential to check the wiring.
The battery compartment terminals must be cleaned when the above parts have been inspected thoroughly. If the terminals are not clean, be sure to clean them well. Each cell of the battery needs to be inspected in order to make sure that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machinery and after that change the filters. The transmission filter, fuel filters and the hydraulic filter should be frequently replaced. Prior to fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
After the oil change is done and the filters have been replaced, a visual inspection of the drive axle has to be performed. If there is a grease fitting on the axle make sure to apply some grease. Check the belts on the engine for any frays or cracks. If you find any, fix the problem accordingly. After that, check every other component of the machine like the wheels. If any type of concern or fault is detected, be certain to address it immediately so as to make sure the machine is running at its safest and optimum levels.